Choosing trekking poles is mainly a matter of matching pole length, locking design, materials, and tips to your height and the terrain you hike. This guide provides a repeatable way to set pole height, compare common designs, and prepare your poles for day hikes, uneven trails, and backpacking trips.
Overview
The best trekking poles for hiking are not necessarily the lightest or most expensive. They should adjust securely, feel comfortable in your hands, pack to a practical length, and suit the surface underfoot. Properly used poles can help with balance, rhythm, and load management, especially on long descents, loose ground, stream crossings, or trails carrying a backpack.
Start with the correct length, then choose a locking system. A useful baseline is to set the pole so your elbow is bent at roughly 90 degrees when the tip is on level ground. Your forearm should be close to horizontal, with your shoulders relaxed rather than raised. Treat this as a starting point: arm length, grip preference, footwear, and terrain can justify a small adjustment.
Starting trekking pole length by height
| Hiker height | Starting pole length | Useful terrain adjustment |
|---|---|---|
| Under 5 ft 1 in / 155 cm | 100 cm | Shorten slightly for steep climbs; lengthen for descents |
| 5 ft 1 in–5 ft 7 in / 155–170 cm | 105 cm | Use a modest change on sustained slopes |
| 5 ft 8 in–5 ft 11 in / 173–180 cm | 110 cm | Adjust for grade, rocks, and pack weight |
| 6 ft–6 ft 4 in / 183–193 cm | 115 cm | Lengthen for descents if your shoulders stay relaxed |
| Over 6 ft 4 in / 193 cm | 120–130 cm | Confirm the pole's maximum adjustment and manufacturer guidance |
The chart is an estimate, not a substitute for a proper fit. If your elbows flare outward, the poles are likely too short. If your shoulders lift or your wrists bend sharply, they may be too long. Check the manufacturer's range before buying, particularly if you need a long setting or a short packed length.
How to estimate
Use a simple three-step method before comparing models:
- Estimate the neutral length. Select the chart length closest to your height, then stand naturally with the pole tips on level ground. Set the handles so your elbows remain comfortably bent.
- Adjust for the route. On a sustained climb, shorten the poles enough to avoid reaching too far uphill. On a descent, lengthen them enough to place the tips ahead without leaning forward. Begin with a small change, such as one adjustment mark or a few centimeters, and refine it while walking.
- Check the packed requirement. If the poles must fit inside or alongside a backpack, compare their collapsed length with your pack's attachment points. Three-section poles usually offer a shorter packed size than two-section designs, although the exact result varies by model.
For mixed terrain, set the poles for the section you will walk most often and use the grip extension, if provided, for brief changes in elevation. Do not sacrifice a secure lock for a few centimeters of extra adjustability. A pole that slips under load is a poor choice regardless of its advertised weight.
Locking systems compared
| System | Strengths | Trade-offs | Best fit |
|---|---|---|---|
| Lever-lock | Quick to adjust, easy to inspect, and simple to operate with cold or gloved hands | External levers can catch on gear and may need occasional tension adjustment | Variable terrain, frequent length changes, and winter use |
| Twist-lock | Clean exterior and compact appearance, with no external lever | Can be harder to operate with gloves; dirt or incorrect tightening can affect grip | Hikers who prefer a streamlined pole and make fewer adjustments |
| Hybrid | Combines different locking approaches to balance adjustment speed and packed size | More parts mean more interfaces to inspect | Backpacking and mixed use when packability matters |
When testing any lock, extend the pole to your intended length and apply firm downward pressure with both hands. The sections should remain fixed without forcing the mechanism beyond its normal setting. Follow the maker's instructions for tension: over-tightening can damage a twist-lock, while an under-tightened lever-lock can slip.
Inputs and assumptions
Your decision becomes clearer when you separate essential requirements from preferences.
- Shaft material: Aluminum is commonly chosen for its practical durability and lower replacement concern. Carbon models can feel light and reduce vibration, but they require more care around sharp impacts and crushing forces. Inspect either material after a hard fall.
- Grip shape: Cork can feel comfortable over long outings and may suit warm conditions. Foam is soft and useful when you change hand positions. Rubber is firm and easy to clean, though comfort varies from person to person. A contoured grip should not force your wrist into an awkward angle.
- Packed length: Measure the actual collapsed length, not just the number of sections. A short packed length matters for travel, small day hiking backpacks, and scrambling approaches where poles are stowed often.
- Baskets: Small baskets are suitable for general trail use. Wider snow baskets help prevent the tips from sinking in soft snow, while mud baskets can be useful on loose or wet ground. Confirm that replacement baskets fit the pole's thread or attachment system.
- Tips: Carbide or metal tips can grip firm natural surfaces, while rubber tips may be preferable on delicate paths, rock slabs, or paved sections. Rubber covers protect the tips during transport but are not always intended as a permanent trail tip.
- Weight and pack style: For a day hike, ease of adjustment and comfort may matter more than minimum weight. For backpacking, compare pole weight with packed size and durability; poles may also support compatible shelter designs, but verify that use before relying on them as tent structure.
Consider your poles as part of a complete trail system. A properly fitted backpack can change your balance and arm position, so test poles while wearing the pack you expect to carry. See our hiking backpack fit and packing checklist for a related fit check, and compare broader weight priorities in our guide to ultralight versus traditional backpacking gear.
Worked examples
Example 1: Mixed day hike
A hiker who is 5 ft 8 in tall can begin around 110 cm. For a rolling route, that neutral setting may work for most of the day. On a longer descent, the hiker can lengthen the poles slightly and confirm that the tips land ahead without causing a forward lean. Lever-lock poles are convenient if the route alternates frequently between climbs and descents.
Example 2: Backpacking in steep terrain
A 6 ft 2 in backpacker can start around 115 cm on level ground. With a loaded pack, the hiker should test the setting before departure because the additional weight can change posture. Shorten the poles for steep uphill travel, then lengthen them for the descent. A dependable lever-lock or well-maintained hybrid may be preferable to a lighter design that is difficult to adjust or inspect.
Example 3: Snow and soft ground
A hiker using poles on snow should check whether the baskets are wide enough to prevent excessive sinking. The neutral shaft length still begins with the hiker's height, but the usable setting may change as the tips sit deeper or the surface varies. Carry the standard baskets or compatible tips if the route includes both snow and exposed trail.
When to recalculate
Revisit your pole setup before each season and whenever a trip differs from your normal hiking. Recalculate or retest when you:
- change from day hiking to a loaded backpacking trip;
- switch footwear or use a different pack;
- move from dry trails to snow, mud, or paved paths;
- notice wrist discomfort, shoulder tension, or repeated tip slips;
- replace a section, lock, basket, or tip; or
- pack the poles for air or vehicle travel and need to confirm their collapsed length.
Before a trip, extend every section and check that the locks hold. Inspect shafts for cracks, dents, or separation; examine tips and baskets for excessive wear; clean dirt from joints; and replace parts only with compatible components. Practice using the wrist straps correctly: slide your hand up through the strap from below, then hold the grip lightly rather than clenching it. Pack rubber tip covers when transporting poles, and secure collapsed poles so they cannot damage other gear.
Use the height chart as your starting calculation, adjust for the route, and test the result with your actual pack. This quick routine is more reliable than choosing poles by weight alone and gives you a repeatable setup for every hike.